Since 2005, 16 Yeares Fire Alarm and Suppression System Manufacturer&Whole Solution Designer
We supply whole fire alarm and suppression system include conventional fire alarm system, addressable fire alarm system, emergency light system, FM200 gas suppression system, fire pump, fire hose reel and cabinet.
  • Home
  • Products
    ASENWARE Fire Alarm Control System are intelligent system which are designed to make it suitable for most of applications. It’s user friendly functionality makes it suitable to program and configure the devices. 7 ” touchscreen display gives the information for fire alarm, trouble , supervisory and other related information all the
    time.This system fully complied with the requirement of EN 54-2 and EN 54-4.
    ASENWARE Fire Pump Series provide fire departments or private users with the ability to pump from any water source.
    The AW-CFP2166 series conventional fire alarm panel is designed based on EN54 part 24 standard. 
    ASENWARE Centralized Monitoring Emergency Luminaire System is designed for managing, monitoring and controlling emergency lights automatically. 
    Asenware FP300 series is a LPCB addressable fire alarm system with one loop of 324 addressable points, comply with EN 54 standard.
    ASENWARE fire fighting telephone system is the special communication equipment for fire fighting
    ASENWARE Heat Detector is photo-electronic detector using a state-of-the-art optical sensing chamber. 
  • Project
  • Newsroom
  • About Us
  • Contact
LPCB approved addressable fire...
Home > Products > LPCB approved addressable fire alarm control system
AW-RP2188 Addressable Repeater for fire alarm system
AW-RP2188 Addressable Repeater is a mated product of the 2188/2100 series fire alarm control panels.
  • The AW-RP2188 fire display panel (display panel for short) is a kind of microprocessor-controlled fire display panel developed by our company. Each display panel is connected to a fire alarm control panel produced by our company via a special RS-485 interface to process and display the data sent from the fire alarm control panel. Each floor of a building may have a display panel installed. When there is a fire alarm on the floor where the display panel is installed, or the neighboring floor above or below it, the display panel will give a horn/strobe alarm and display the floor No., the room No., and some other position information of the fire alarm.


  • Addressable Fire Alarm Repeater Feature:

    1. Each display panel is connected with a fire alarm control panel via a RS-48 bus. At most 99 display panels may be connected with each RS-485 bus.
    2. The display panels can display fire alarm messages or feedback messages only rather than fault messages, action messages or other messages.  
    3. A fire alarm control panel may be used for setting the display area of a display panel. The set display panel can display the fire alarm messages of the designated area (floor display) only. Note: See the User’s Manual of the fire alarm control panel for the setting method.
    4. It can replace a AW-AFP2100 fire display panel in a 2100 system.
     
  • Addressable Fire Alarm Repeater Technical parameters:

    1. Executive standard: General Technical Conditions for Fire Indicating Panels (GB17429-1998)
    2. Display capacity: Each display panel can display the fire alarm messages of floors -10~90 and at most 99 fire alarm messages or feedback messages.
    3. Wiring system: Four-wire system, power lines (+24V, GND) and RS485 signal lines (485A, 485B);
    4. Operating environment: Indoor; temperature: -10℃~+50℃; relative humidity: ≤95% (40℃, without condensation);
    5. Power supply: DC 24V ±20 %;
    6. Overall power consumption: <3W;
    7. Contact capacity: Relay dry contacts, normally open or normally closed, capacity: 1.25A/DC30V (resistive load).